aFe
Pro-GUARD 7
Intake Systems
Featuring a new filtration technolgy so revolutionary that aFe has
applied for a patent!5 layers of progressively finer mesh medical
grade cotton guaze with micro fibers that attract smaller and
smaller particles as air passes through.
Combined with 2 layers of random-porosity non-woven synthetic
polyester fabric with random porosity. Sandwiched by 2 layers of
aluminum wire mesh.
100% polyurethane construction with progressive seal
Tall open pleat geometry
Quality you can see
1. Washable/Reusable cotton-synthetic media will not collapse even
when wet.2. Built-in expandable metal (on selected filters) to
prevent collapse under high boost pressures.
3. Pliable progressive polyurethane seal to ensure tight seal
without gaskets or sealant.
4. 100% polyurethane construction to withstand extreme engine
temperatures and extend service life.
Pro Guard 7 Independently Proven
Quality!
Excerpts of a Letter from Dan Montegari - President of Precision
Diesel Services
We received many letters asking which high flow air intake
systems to use. We decided to test a number of manufacturers'
systems to determine which system was superior. We tested each
system and found systems manufactured by aFe (Advanced Flow
Engineering) were the BEST by far.
Diesel engines use seven times more air than gasoline engines
of equivalent size so clean cool air is a must for extended engine
life, better fuel economy, and additional power. A higher flow of
intake air coupled with a high flow exhaust system allows for more
power, a better fuel economy, extended engine life and reduced
exhaust temperatures. On the other hand ingested dirt through the
air intake system becomes Silicon in the engine oil, which is a
harsh cutting agent and can damage your engine quickly.
We tested three very popular systems. We evaluated the systems
by a number of criteria, filtration protection, flow, design, ease
of installation, and cost.
Two manufacturers claimed their systems delivered cleaner air
at a higher flow, but this was far from the truth. We did not
believe any of the manufacturers' claims and tested each system by
operating the vehicle 3,000 miles and performing an engine oil
analysis performed at every oil change so they had a Silicon number
of three (3) to base their tests on.
I installed the Pro-GUARD 7 filter, changed the engine oil and
operated the vehicle for three thousand miles. The engine oil
analysis was excellent with a Silicon reading of below three (3).
Finally we found an air intake system that gave us a higher flow
rate and better filtration. The aFe Magnum Force air intake system
is a well-designed system, easily installed and uses about 90%
outside air. The filter is cleanable and the oil used to coat the
filter is patented because it is formulated not to affect the
airflow sensor.
Another positive factor of the high flow system was the fuel
economy increased about 1/2 MPG in mixed driving and 1 MPG during
highway tests. The filter media used by aFe will not collapse if it
gets wet of subjected to high boost pressures.....
Dan Montegari
President
Precision Diesel Services, Inc.
Read the unedited letter
|
7 Ways To Keep Dirt OUT and Get More
Air IN!
Maximum Protection
When you use your vehicle in a severe duty or work application, it
is important to give the engine a high level of protection from dirt
and dust. With 7 layers of media, Pro-GUARD 7 is able to offer a
level of protection to the engine that is unsurpassed. Even fine
dust is effectively filtered out and kept from entering the engine
intake. When the vehicle need to make it through the long haul,
Pro-GUARD 7 will offer the protection you need.
High Efficiency
Efficiency refers to a filters ability to efficiently filter out the
dust and dirt particles from entering the air intake of the vehicle.
Pro-GUARD7 was developed with the need for high efficiency in mind.
With a filtration media that is able to stop the coarse and fine
particles of dust from entering the engine. Typical
performance/cotton gauze filters will give you the air flow you
need, but have to sacrifice efficiency to do so. The Pro-GUARD7
filters can offer both a high air flow along with the high
efficiency you need.
Greater Dust Holding Capacity
Holding more dust simply means that you will end up with a longer
interval before needing to service your filter. In fact, a Pro-GUARD
7 filter can hold over 11 times the dust of a paper filter before
needing to be cleaned or serviced, without degrading engine
performance. The layers of cotton and synthetic media are able to
hold the dirt while still allowing air to pass through. The single
layer of a paper filter becomes plugged as soon as a dirt particle
deposits itself onto the filter media...that means less air getting
to your engine.
Longer Service Life
The less often a filter requires cleaning or service, the better.
Especially considering the maintenance costs involved with work and
fleet vehicles, minimizing the frequency of maintenance and getting
a longer life out of any part is a benefit to the bottom line.
Because of the excessive dirt holding capacity of the Pro-GUARD7
filter line, typical service interval is 50,000 miles on the road,
or 25,000 miles in severe duty applications.
Better Air Flow
Allowing more cool, clean, unrestricted air flow is a key element in
increasing engine performance. Pro-GUARD7 filtration technology
allows air flow that matches the performance of cotton-gauze
filters. Increasing the amount of air the engine can bring in, and
doing it with less restriction increases horse power and torque. It
can also increase mileage and lower exhaust gas temperatures
depending on the driving environment of the vehicle. Pro-GUARD7
offers this level of performance without sacrificing filtration
efficiency.
More Power
Giving your engine more power and letting it breath easier
translates simply into more power. More horsepower, more torque,
faster turbo spool up, and lower EGT's are all the result of letting
your engine have the air that it needs. You will especially feel the
power when you are towing or climbing a hill.
Better Value
Extended service interval, higher air flow, and the long term
protection help with the total cost of vehicle ownership and
operation. Value is more that what you pay for a part. It is a
combined look at the total cost of ownership of the vehicle. The
Pro-GUARD7 filter and intake line offer tremendous value by
increasing power, lowering maintenance costs, and avoiding the
continual replacement of disposable filters.
Order your Pro-Guard 7 below. Just
click on your brand logo.
|