New From ENKAY Rock Tamer Mudflaps
They are bold and sexy! I consider them the best built mudflaps I've found. I still love the old model and they are bullet proof. I've had them in sagebrush off road and the only thing that hurt them was the spray arm in a car wash. And all I did was bend the rod back and on the road I go.
The new model has a polished aluminum yoke, as the old model was brass. The new model has heavy wall aluminum tubing instead of steel rod. Still adjustable in and out and up and down. Which is so good for my truck reviews which range from a tall H2 to a Nissan Frontier. And I review new trailers too, so protecting the trailer from Interstate gravel, keeps the trailers coming.
Matte Black
Powder Coated Alum
inum #00108
(below)
Style One Size
Fits all from 66.75" to 93.75" width Order $249.99
FREE Shipping
Alaska, Hawaii, Canada or Express Shipping, $70 extra click
Any mudflaps can protect your trailers from mud, that's a slow speed problem. But the damage comes from the little rocks and gravel that are on the roads from wind and snow plows. And those little rocks get propelled when you're going 70 mph +. The old Rock Tamers had a two pound weight embedded in the bottom of the rubber flap. This kept the mudflaps from sailing at higher speeds which is where the protection is needed. The new model is a thick rubber flap with vertical ribs which keep the mudflaps pointing down at 70 mph +. Now they are better looking, a bold tough look with a sculptured chrome plated aluminum yoke and big horizontal tubes holding the thick rubber flaps with a stainless steel Rock Tamer plate at the bottom.
These are the most heavy duty, adjustable mudflaps I've found, and I look hard. They won't sail down the road, but stay in place and now they look like a bling, bling accessory that makes your truck look cooler. Function and beauty, just like me. Kent Sundling, (MrTruck)
|
|
|
|
|
|
| The yoke fits 2 inch drawbar stingers. The drawbar that attaches to your trucks receiver hitch. | Everything you need for installation including a hole punch for the template height adjustment holes. | Start your install with the chrome plated yoke on your 2" ball drawbar. | Add the stainless steel plates on the flaps. | Yoke has three set bolts to clamp the aluminum tube. The bump on the end is rotated to the side and keeps the tube from pulling out. |
|
|
|
|
|
|
| Heavy tube aluminum supports the mudflaps. | Yoke and tubes ready for flaps. | Just size the mudflaps to what length you need and cut the template lines and holes. No drilling. | Sleeve slides over pipe for adjustment from 66.75" to 93.75" for compact trucks to duallies. | Plastic protective caps on each end of the aluminum tube. |
|
|
|
|
|
|
| Inside aluminum tube adjusts to extend the mudflaps out and so does the sleeve the flaps are attached to. | On the back of the mudflaps are built- in templates for different lengths to fit your truck and SUV. | And Rock Tamers come with a hole punch to finish the template holes. | Mudflaps are 24 inch x 24 inch | Finished, just add
trailer and stir
|
